Saturday, February 6, 2010

Draw Test Automotive Test Procedure For A Parasitic Draw Test On A Automotive Battery.?

Test procedure for a parasitic draw test on a automotive battery.? - draw test automotive

describe the testing process to detect parasites develop, and why you have this test?

2 comments:

dodge man said...

You can use an ohm meter or test illuminated LED 12-volt, lamp test indicating the drawing of light when this happens, remove the negative cable easily and connect a test lamp or ohmmeter between the post and battery cable will see further, whether the light or ohm meter is read and what is that if you can use an ohm meter sometimes much more quickly by limiting the amount of volts, amperes, or when removing the battery, light test that you can go to the brilliance to determine it by the height of the drawing and its use is usually much faster and easier to use and see, I use the two times you need to ensure what is key is disabled and not in the accessories and all doors are closed, and then see if you draw blood, is a relatively simple procedure and is the best way to short to not tie it, you can not with any positive or negative, of a cable show a draw when an ohmmeter positive Wire works best to use a lot of luck.

Christia... said...

disconnect the negative cable and then install and test on a beamline. Because the evidence of all good, but the battery is dead. Hope that you ask the right questions to your test =)

In a newer car is a little closer, but the principle remains the same.

Post a Comment